Modifying Igmp Snooping - Cisco Linksys SFE1000P Reference Manual

– Unchecked — Disables IGMP Snooping on the device.
• VLAN ID — Specifies the VLAN ID.
• IGMP Snooping Status — Indicates if IGMP snooping is enabled on the specific VLAN. The
possible field values are:
– Enable — Enables IGMP Snooping on the VLAN.
– Disable — Disables IGMP Snooping on the VLAN.
• Host Timeout — Indicates the amount of the time the Host waits to receive a message before
it times out. The default value is 260 seconds.
• MRouter Timeout — Indicates the amount of the time the Multicast router waits to receive a
message before it times out. The default value is 300 seconds.
• Leave Timeout — Indicates the amount of time the host waits, after requesting to leave the
IGMP group and not receiving a Join message from another station, before timing out. If a
Leave Timeout occurs, the switch notifies the Multicast device to stop sending traffic The
Leave Timeout value is either user-defined, or an Immediate Leave value. The default timeout
is 10 seconds.

Modifying IGMP Snooping

The Edit IGMP Snooping Page provides a means of configuring snooping parameters.
The Edit IGMP Snooping Page contains the following fields:
• VLAN ID — Specifies the VLAN ID.
• IGMP Status Enable — Indicates if IGMP snooping is enabled on the VLAN. The possible
field values are:
– Enable — Enables IGMP Snooping on the VLAN.
– Disable — Disables IGMP Snooping on the VLAN.
Chapter 10: Configuring Multicast Forwarding
IGMP Snooping
SFE1000P Gigabit Ethernet Switch Administration Guide
Edit IGMP Snooping Page
Chapter
10
109