Modifying Profile Rules - Cisco Linksys SFE1000P Reference Manual

• Interface — Defines the interface on which the access profile is defined. The possible field
values are:
– Port — Specifies the port on which the access profile is defined.
– LAG — Specifies the LAG on which the access profile is defined.
– VLAN — Specifies the VLAN on which the access profile is defined.
• Source IP Address — Defines the interface source IP address to which the access profile
applies. The Source IP Address field is valid for a subnetwork.
– Network Mask — Determines what subnet the source IP Address belongs to in the
network.
– Prefix Length — Defines the number of bits that comprise the source IP address prefix, or
the network mask of the source IP address.
• Action — Defines the action attached to the rule. The possible field values are:
– Permit — Permits access to the device.
– Deny — Denies access to the device. This is the default.

Modifying Profile Rules

The Edit Profile Rule Page contains the following fields:
• Access Profile Name — Defines the access profile name. The access profile name can
contain up to 32 characters.
• Priority — Defines the rule priority. When the packet is matched to a rule, user groups are
either granted permission or denied device management access. The rule number is
essential to matching packets to rules, as packets are matched on a first-fit basis. The rule
priorities are assigned in the Profile Rules Page.
Chapter 5: Configuring Device Security
Defining Access Method
SFE1000P Gigabit Ethernet Switch Reference Guide
Edit Profile Rule Page
Chapter
5
36