Figure 1-5. On Cl And Cx Models, Make Sure You Disconnect The Fan; Figure 1-6. Location Of The Voltage Selection Jumpers And The Voltage Selection Wire; Figure 1-7. Location Of The Voltage Selection Tabs And Connector - High End Systems Cyberlight User Manual

4. Carefully lift the lamp box access door from the fixture.
5. CL and CX models only: As you lift the assembly, disconnect the two fan power connectors
(black and red wires) from the power supply board as shown in Figure 1-5. Set the lamp box
access door aside. You now have access to the power supply board.
Figure 1-5. On CL and CX models, make sure you disconnect the fan power wires
from the fan connectors before removing the lamp box access door.

Figure 1-6. Location of the voltage selection jumpers and the voltage selection wire.

6. Locate the four voltage and frequency selection tabs shown in Figure 1-7; they are on the left
side of the power supply board.

Figure 1-7. Location of the voltage selection tabs and connector.

Chapter 1 Installation and Setup 1-13
1