Installing The Yoke; Figure 1-8. Components Of The Cyberlight Yoke - High End Systems Cyberlight User Manual

7.
8.
9.
10. Connect the safety chain to the center access door and replace the door (see Step 1 on page

Installing the Yoke

You will need:
1.
2.
3.
4.
5/16 inch allen
bolts – insert through
yoke and into
fixture
1-14 Cyberlight User Manual
Note which of the four tabs currently has the jumper wire attached. If you need to change the
voltage/frequency setting, grasp the connector and pull or wiggle it to remove it from the tab.
Make sure you pull on the connector and not on the wire.
Move the voltage selection wire to the desired tab and firmly press the connector onto it. If the
connector has spread from use, gently squeeze it together with pliers. A loose connector will
overheat and turn brown.
Reinstall the lamp box access door with the six screws in the reverse order in which you
removed them (see Step 3 on page 1-12).
1-11).
(The items listed below are shipped with the Cyberlight)
– two 5/16 inch carriage bolts
– two clamping T-handles
– yoke
– two 5/16 inch allen cap screws
– two 9/16 inch locknuts (nut with nylon insert)
(The items listed below are NOT shipped with the Cyberlight)
- 5/16 inch allen wrench
- 9/16 inch socket wrench or 9/16 inch wrench
If the fixture has been running recently, allow it to cool for at least 10 minutes. Then turn the
power OFF.
Remove the center access door. You do not need to unlatch the safety chain.
Stand the fixture on its end handles.
Insert the carriage bolts through the star-shaped hole in the yoke and attach the clamping T-
handles to the carriage bolts. The T-handles should not be very tight; you will adjust them
later. Figure 1-8 shows the orientation of parts.
Clamping
T-Handle
9/16 inch
locknuts

Figure 1-8. Components of the Cyberlight yoke.

Yoke
5/16 inch carriage
bolts
Clamping
T-handle