Figure 3-19. Location Of The Color Mixing Flags And Dim Flags; Removing And Cleaning The Rotating Lithos - High End Systems Cyberlight User Manual

10. Make sure the infrared filter, reflector, color mixing flags and dim flags are all clean.
11. Carefully guide the lamp assembly straight back into the fixture and make sure the lamp is
12. Reinstall the lamp assembly cover. Do the following:

Removing and Cleaning the Rotating Lithos

You can clean the rotating lithos in or out of the rotating litho wheel using a mild glass cleaner and
a soft cotton cloth. Turn the rotating wheel so that you have easy access to the litho then clean the
lithos while they are still mounted in the wheel.
If you wish to remove the litho for cleaning follow the procedure in the section titled "Removing
and Installing Rotating Lithos". Then clean the litho with a mild glass cleaner and a soft lint free
cloth.
3-14 Cyberlight User Manual
• The CX has no color mixing flags. The two dim flags are located in the area shown in
Figure 3-19.

Figure 3-19. Location of the color mixing flags and dim flags.

inserted into the reflector. Be careful not to crimp the two lamp wires as you insert the lamp
assembly. Firmly tighten the two lamp assembly screws (refer to Figure 3-13 on page 3-11) to
secure the assembly to the fixture.
• CL and CX only: Reconnect the two fan wires to the Cyberlight power supply board.
Refer back to Figure 3-17 on page 3-13.
• Carefully replace the lamp box access door.
• Reinstall the six 5/32 inch screws (refer to Figure 3-15 on page 3-12 and Figure 3-16 on
page 3-12).