Figure 3-26. Insert The New Or Cleaned Litho Into The Rotating Litho Housing As Described Above; Improper Installation Can Cause Heat Damage To The Litho; Figure 3-27. Turn On The Spring As You Push It Into The Rotating Litho Housing - High End Systems Cyberlight User Manual

5.
Caution
6.
7.
3-20 Cyberlight User Manual
Insert the new or cleaned litho into the litho housing as shown in Figure 3-26. Make sure you
orient the litho as explained below:
• Any LithoPatterns or any Psy-Dye lithos, including Psy-Dye Special Effects: the
coated side of the litho must face away from the lamp; uncoated (glass) side faces toward
the lamp.
• Flat unglazed Art Glass or Special Effects other than Psy-Dye: the non-textured side
must face away from the lamp; textured side faces toward the lamp.
• Multi-Color lithos with stainless steel holder: the solid flat side of the stainless steel
litho holder must face away from the lamp (i.e., the flat side of the holder must be against
the wheel hub).
Improper installation can result in heat damage to the litho. Use care
when installing the litho; make sure you handle it by the edge only and do
not allow it to contact any other object in the fixture while you are
inserting it.
Toward lamp
Figure 3-26. Insert the new or cleaned litho into the rotating litho housing as
described above; improper installation can cause heat damage to the litho.
Insert the spring into the housing as shown in Figure 3-27.

Figure 3-27. Turn on the spring as you push it into the rotating litho housing.

To lock the litho in place, begin working the spring under any one of the three retainer washers
until the spring is fully compressed as shown in Figure 3-28. (The retaining washers are
Away from lamp
Side view of
rotating litho
housing
Turn the spring as you push in on it