High End Systems Cyberlight User Manual page 11

Figure 3-15. Location of the first four rear panel screws you need to remove in
Figure 3-16. In order to remove the lamp box access door, you need to
Figure 3-17. On CL and CX models, make sure you disconnect the fan
Figure 3-18. Locations of the reflector and infrared filter. ..................................... 3-13
Figure 3-19. Location of the color mixing flags and dim flags. ............................. 3-14
Figure 3-20. View of the bottom of the Cyberlight fixture, where the access
Figure 3-21. Removing the rear panel screws allows you to access the
Figure 3-22. In order to remove the lamp box access door, you need to
Figure 3-23. On CL and CX models, make sure you disconnect the fan
Figure 3-24. Location of power supply board fuses. .............................................. 3-18
Figure 3-25. Removing the center access door. ...................................................... 3-19
Figure 3-26. Insert the new or cleaned litho into the rotating litho housing as
Figure 3-27. Turn on the spring as you push it into the rotating litho
Figure 3-28. Make sure the end of the spring fits under any one of the
Figure 3-29. Do not place the end of the spring between the three
Figure 3-30. Push the dichroic/litho toward the large retaining tab to free
Figure 3-31. Adjusting the Cyberlight CX mechanical zoom lens. ........................ 3-23
Figure 3-32. Loosen the three 5/32 inch allen screws and the T-handle
Figure 3-33. Grasp both sides of the mirror head and rotate it to the
Figure 3-34. Be sure to note the deviation angle in case you need to set
Figure 3-35. Adjust the yoke handles on both sides of the Cyberlight
Cyberlight User Manual
x
order to access the lamp assembly. ..................................................... 3-12
remove the last two 5/32 inch allen screws, which are located
by the color mixing and dim flags. ..................................................... 3-12
power wires from the fan connectors before removing the
lamp box access door. ......................................................................... 3-13
door latches are located. ..................................................................... 3-16
Cyberlight voltage selection jumpers. ................................................ 3-16
remove the last two 5/32 inch allen screws, which are located
by the color mixing and dim flags...................................................... 3-17
power wires from the fan connectors before removing the
lamp box access door. ......................................................................... 3-17
described above; improper installation can cause heat damage
to the litho. .......................................................................................... 3-20
housing. .............................................................................................. 3-20
three retaining washers, as shown above. ........................................... 3-21
retaining washers. ............................................................................... 3-21
it from the wheel tabs. ........................................................................ 3-22
to adjust the mirror head deviation. .................................................... 3-24
desired position. .................................................................................. 3-25
other fixtures for the same deviation, or if you want to use
this exact deviation again. For example, the figure above has
about a 10° + (plus) deviation. .......................................................... 3-25
to tilt the fixture in a specific way. ..................................................... 3-26