High End Systems Cyberlight User Manual page 67

7.
8.
Note
2-20 Cyberlight User Manual
If the spring plunger does contact the rotating litho wheel, proceed with Step 8. Otherwise, do
the following:
• Use a 7/16 inch wrench to loosen the hex nut shown in Figure 2-9.
• Use a 5/64 inch allen wrench to turn the allen screw shown in Figure 2-9. This allen screw
moves the spring plunger in and out. Adjust the plunger so that it makes contact with the
rotating litho wheel.
• Use a 7/16 inch wrench to retighten the hex nut.
Repeat Steps 4 through 7 until you are sure there is no contact between either the rotating litho
wheel or an individual rotating litho and any other object in the fixture.
You can turn the rotating litho wheel until both the wheel and the lithos are locked in place
(they will not move). This is the normal "homed" position of the wheel.