Figure 3-13. Location Of Lamp Assembly And Optimization Screws; Figure 3-14. Removing The Lamp From Its Brass Socket - High End Systems Cyberlight User Manual

2. Fully back out the two lamp assembly screws shown in Figure 3-13. The screws have retaining
springs that prevent them from being removed.

Figure 3-13. Location of lamp assembly and optimization screws.

3. Grip the three lamp optimizing screws and pull the lamp assembly straight out of the back of
the fixture. The lamp's power cord is long enough to allow you to pull the lamp assembly
entirely free of the Cyberlight.
4. Carefully set the lamp assembly aside. You can remove the lamp, if you wish, and place it
where it will not get broken. Pull it straight out of the socket as shown in Figure 3-14.

Figure 3-14. Removing the lamp from its brass socket.

5. Using the 5/32 inch right angle allen wrench, remove the four 5/32 inch allen screws shown in
Figure 3-15.
Brass socket
Chapter 3 Servicing Your Cyberlight 3-11
3