Mounting The Fixture; Standing The Fixture On Its End Handles - High End Systems Cyberlight User Manual

Mounting the Fixture

Cyberlight is designed to be mounted in any orientation; you can even stand the fixture on its end
handles. However you wish to mount the fixture, you must follow the precautions and suggestions
below:
• Verify the input voltage you are using matches the Cyberlight fixture's voltage selection
jumpers (see the section titled "Electrical Specifications" on page 1-4 and "Changing the
Voltage Selection Jumpers" on page 1-11).
• Heed the cautions and warnings below to guard against personal injury and damage to the
fixture.
Cautions (1) This equipment for connection to branch circuit having a maximum
overload protection of 20 A.
(2) Class I Equipment - This fixture employs a grounded type receptacle
and is not intended for connection to a two wire, ungrounded source of
supply.
(3) Mount the fixtures and controllers in a location that is away from
direct heat and protected from moisture. Do not mount on a flammable
surface.
(4) Maintain minimum distance of 1.0 meter (3.28 feet) from combustible
materials. Observe minimum distance to lighted objects of 1.0 meter
(3.28 feet).

Standing the Fixture on its End Handles

The Cyberlight end handles are designed to support the weight of the fixture; however, make sure
you observe the following guidelines:
• The fixture must be located away from moving objects that could strike it and cause it to
become unbalanced.
• The fixture must be mounted on a sturdy, stable surface.
• If the surface is other than floor height, make sure you use safety cables as described in the
next section.
Chapter 2 Using Your Cyberlight
2
2-9