Figure 1-16. High End Systems Recommends You Replace The Cl Color; Cto Correction Filter, And The Aqua Filter (At Position 5 With The Homogenizing Frost Filter; Figure 1-17. Push The Dichroic Filter Toward The Large Retaining Tab To Free It From The Wheel Clips - High End Systems Cyberlight User Manual

Color Wheel Before
1. Open
2. Red
3. Purple
4. CL Color Corrector
5. Aqua
6. Blue
7. Orange
8. Indigo
7
Figure 1-16. High End Systems recommends you replace the CL color correction
filter (at position 4) with the salmon-colored CTO correction filter, and the aqua filter
(at position 5) with the homogenizing frost filter.
Note Wheel positions are numbered starting at the open hole (position 1). The other seven
positions are numbered counter-clockwise from position 1 when you are facing the color
wheel toward the lamp.
3. Push the filter you wish to replace toward the center of the wheel to free it from the two wheel
tabs as shown in Figure 1-17:
Figure 1-17. Push the dichroic filter toward the large retaining tab to free it from the
wheel clips.
4. Once the dichroic is free of the two wheel tabs, pull it out of the wheel. Place the dichroic you
just removed in a safe place where it will not get scratched.
5. Orient the CTO color corrector so the coated side is facing the lamp, and with the glass side
facing away from the lamp as shown in Figure 1-18. (The smoky-looking homogenizing frost
Color Wheel After
1. Open
2. Red
3. Purple
4. CTO Color Corrector
5. Homogenizing Filter
6. Blue
7. Orange
8. Indigo
5
6
4
3
2
8
1
Open
You will replace
these two dichroics
Chapter 1 Installation and Setup 1-21
1