Putting The Fixture Into Use - High End Systems Cyberlight User Manual

Putting the Fixture Into Use

Before putting the Cyberlight fixture into use, you need to do the following:
•
•
•
•
•
•
WARNINGS:
1-28 Cyberlight User Manual
Make sure the Cyberlight power cord cap is wired correctly.
Make sure the Cyberlight is set for the correct voltage. Appendix D contains a listing of
typical voltages worldwide. You should always verify the proper voltage with a local authority
in your venue.
Make sure you configured the fixture properly as described in this chapter.
If you are connecting the fixture to a controller, see Chapter 2. If you are controlling the
Cyberlight with DMX 512 protocol, also see Appendix A (for DMX 512 control).
See the section titled "Mounting the Fixture" on page 2-9.
Heed all of the warnings below:
• Do not mount on a flammable surface.
• Maintain minimum distance of 1.0 meter (3.28 feet) from
combustible materials.
• Observe minimum distance to lighted objects of 1.0 meter (3.28
feet).
• This equipment for connection to branch circuit having a
maximum overload protection of 20 A.
• Equipment suitable for dry locations only. Do not expose this
equipment to rain or moisture.
• Refer servicing to qualified personnel; no user serviceable parts
inside.
• Class I Equipment - this fixture employs a grounded type
receptacle and is not intended for connection to a two wire,
ungrounded source of supply.
• Heed all other Cautions and Warnings in this manual and printed
on fixture labels.