Figure 3-32. Loosen The Three 5/32 Inch Allen Screws And The T-Handle To Adjust The Mirror Head Deviation; Adjusting The Mirror Head Deviation - High End Systems Cyberlight User Manual

Adjusting the Mirror Head Deviation

You will need:
You can easily pivot or offset the mirror head deviation up to 20 degrees left or right of center for a
total range of 40 degrees.
1.
Note
2.
3-24 Cyberlight User Manual
- 5/32 inch right angle allen wrench
Using an allen wrench, loosen the three 5/32 inch allen screws shown in Figure 3-32. Using
your hand, loosen T-handle that locks the mirror head in position.
Loosen these 5/32" allen screws
Figure 3-32. Loosen the three 5/32 inch allen screws and the T-handle to adjust the
mirror head deviation.
The mirror head deviation adjustment can be performed with the Cyberlight positioned
either on its back (as is shown in Figure 3-32) or on its front.
Grasp both sides of the mirror head and rotate it until it is positioned according to your needs.
See Figure 3-33.
Loosen this T-handle