Linking The Fixtures To The Controller - High End Systems Cyberlight User Manual

Linking the Fixtures to the Controller

Starting with the controller, link fixtures using the procedure below. Refer also to Figure 2-4.
1.
2.
3.
4.
5.
6.
2-8 Cyberlight User Manual
Start with the controller. Consult the documentation provided with the controller for the
procedure to connect XLR cable to its Data Out connector.
Connect the female end of the XLR cable from the controller to the first Cyberlight fixture's
male Data In connector.
Connect the male end of another XLR cable to the first Cyberlight fixture's female Data Out
connector.
Continue connecting the Data Out connector from one Cyberlight to the Data In connector to
the next Cyberlight until you have linked all of the Cyberlight fixtures.
Connect other devices to the Cyberlight fixtures as desired, using the instructions in the
documentation provided with those devices.
Place a male 120 ohm terminator on the female Data Out connector of the last device in the
link. (This is true for both DMX 512 protocol or LWR protocol.) The procedure for making a
terminator can be found in the section titled "Terminators" on page 2-7.
Figure 2-4. Make sure you connect the Data Out connector from the previous
Cyberlight to the Data In connector of the next Cyberlight. Also, you must terminate
the Data Out connector of the last device in the link (whether the last device is a
Cyberlight or something else).