Figure 3-20. View Of The Bottom Of The Cyberlight Fixture, Where The Access Door Latches Are Located; Figure 3-21. Removing The Rear Panel Screws Allows You To Access The Cyberlight Voltage Selection Jumpers - High End Systems Cyberlight User Manual

1.
2.
3.
3-16 Cyberlight User Manual
After allowing the fixture to cool as described on the previous page, turn the power switch OFF
and unplug the fixture.
With the fixture oriented bottom-side up, remove the center access door by sliding the two door
latches inward. Lift the door straight up, unhook the safety chain, and set the door aside. See
Figure 3-20.
Figure 3-20. View of the bottom of the Cyberlight fixture, where the access door
latches are located.
Remove the fixture's lamp box access door by removing the six 5/32 inch allen head screws
securing it to the fixture as follows:
• Remove the four 5/32 inch allen head screws from the bottom of the rear panel as shown in
Figure 3-21.
Figure 3-21. Removing the rear panel screws allows you to access the Cyberlight
voltage selection jumpers.