Figure 1-2. View Of The Bottom Of The Cyberlight Fixture, Where The Access Door Latches Are Located; Changing The Voltage Selection Jumpers - High End Systems Cyberlight User Manual

Changing the Voltage Selection Jumpers

You will need: - one right angle 5/32 inch allen wrench
Warnings: (1) An unshielded MSR/MSD 1200 lamp emits ultraviolet and visible
(UV-vis) radiation which could damage eyes and skin. Wear eye and
hand protection when re-lamping. Never look directly at the lamp while
lamp is on.
(2) Hot lamp may be an explosion hazard. Do not open for 5 minutes
after switching off.
(3) Equipment surfaces may reach temperatures up to 62° C (144° F).
Allow 10 minutes for cooling before handling
(4) To avoid the risk of electric shock, turn the fixture OFF and unplug it
from the power source before performing this service.
1. After allowing the fixture to cool as described above, turn the power switch OFF and unplug
the fixture. Refer to the section titled "Setting the Cyberlight Power Switch" on page 1-29 for
power switch settings.
2. With the fixture oriented bottom-side up, remove the center access door by sliding the two door
latches inward. Lift the door straight up, unhook the safety chain, and set the door aside. See
Figure 1-2.
Figure 1-2. View of the bottom of the Cyberlight fixture, where the access door
latches are located.
.
Chapter 1 Installation and Setup 1-11
1