Figure 2-7. Loosening The Hub Screws Allows You To Adjust The Wheel's Clearance; Checking And Correcting Wheel Clearances - High End Systems Cyberlight User Manual

Checking and Correcting Wheel Clearances

You will need:
Use the procedure in this section to check for clearances between wheels and their sensors, or
between wheels and other objects in the Cyberlight fixture.
1.
2.
2-18 Cyberlight User Manual
- 1/16 inch right angle allen wrench
- 7/16 inch wrench
- 5/64 inch allen wrench
Manually turn the color wheel and effects wheel to make sure there is no contact between them
and any other object.
If there was any contact, adjust the wheel's clearance by taking the three actions below:
• using a 1/16 inch right angle allen wrench, loosen the two hex screws on the wheel's hub
(the rotating litho wheel is shown in Figure 2-7)
• press on the center of the wheel to move the hub until there is no longer any contact
between the wheel and its sensor or any other object in the fixture
• retighten the screws

Figure 2-7. Loosening the hub screws allows you to adjust the wheel's clearance.