Setting The Personality Dip Switches; Figure 1-18. Orient The Coated Side Of The Dichroic Toward The Lamp And The Uncoated Side Toward The Static Litho Wheel; Figure 1-19. The Personality Switches - High End Systems Cyberlight User Manual

Caution
6.

Setting the Personality DIP Switches

There are two sets of DIP switches located on the rear panel of the Cyberlight fixture: personality
(the top set) and DMX address (the bottom set). Refer back to Figure 1-1 if you are not sure of the
location of these switches.
The personality switches (shown in Figure 1-19) determine the fixture's operating mode. You can
use these switches for testing, setup, and for control of specialized parameters. Setting all the
switches OFF is the normal operating mode when using the fixture with a Lightwave Research
(LWR) protocol controller, such as the Status Cue system or the Cyberlight LCD controller. Note
that a switch is ON when it is adjacent to the switch number and OFF when it is away from the
switch number.
1-22 Cyberlight User Manual
filter can be installed with either side facing the lamp.)
Figure 1-18. Orient the coated side of the dichroic toward the lamp and the uncoated
side toward the static litho wheel.
Be careful not to allow the filters to contact other objects during
installation. Doing so could scratch them.
Push the new filter into the large retaining clip on the wheel, then pull it up so it fits under the
wheel tabs.

Figure 1-19. The personality switches.