Personality Switch Setting Descriptions; Switch 1: Self-Test; Switch 2: Setup Mode - High End Systems Cyberlight User Manual

Personality Switch Setting Descriptions

All Switches Off: Normal Mode
When all switches are OFF, the fixture must be controlled by Lightwave Research (LWR)
control protocol. For more about LWR and DMX 512 control protocols, see Chapter 2.

Switch 1: Self-Test

Switch 1 On – Setting switch 1 ON starts an internal self-diagnostic routine which verifies the
major functions of the fixture.
After setting switch 1 to ON, the fixture homes (you will hear gears turning and clacking). Except
for the homing procedure, which is performed only once, the self-test repeats until you set switch 1
back OFF.
Note Setting switch 1 ON overrides any controller that might be attached to the fixture. You
must set switch 1 back to OFF before attaching a controller to the fixture.
A controller is not required for the self-test. However, if you do have a controller you might want to
verify fixture functionality under either DMX or LWR control. If you are using the Status Cue
system to control the Cyberlight, refer to its documentation for the procedure. If you are using
another controller, refer to the documentation shipped with the controller and also to Appendix A.
Switch 1 Off – This is the normal operating mode. During normal operation the motor, fan, and
lamp LEDs on the rear panel are ON (see Table 1-3 for a description of rear panel LEDs).

Switch 2: Setup Mode

Switch 2 On – Setting switch 2 ON causes the lamp to strike. This allows you to adjust (optimize)
the lamp without connecting the fixture to a controller. It is very important to optimize the lamp
before operating the fixture with a newly-installed lamp. Failure to do so could result in damage to
the fixture. (See "Optimizing the Cyberlight Fixture Lamp" on page 1-18.)
Note Setting switch 2 ON overrides any controller that might be attached to the fixture. You
must set switch 2 back to OFF before attaching a controller to the fixture.
Switch 2 Off – Normal operation.
Chapter 1 Installation and Setup 1-23
1