General Maintenance And Cleaning - High End Systems Cyberlight User Manual

General Maintenance and Cleaning

You should clean your Cyberlight after each lamp change to maintain performance and reliability,
since dust and dirt can accumulate and cause overheating or malfunctions.
Warning
After allowing the fixture to cool down and powering it off, see one of the topics listed below:
•
•
•
•
Cyberlight User Manual
3-2
Before performing any service or maintenance, make note of the
following:
(1) Hot lamp may be an explosion hazard. Do not open for 5 minutes
after switching off. Wear eye and hand protection when re-lamping.
(2) Equipment surfaces may reach temperatures up to 62° C (144° F).
Allow 10 minutes for cooling before handling.
(3) Disconnect power before re-lamping or servicing.
"Cleaning the Fans" on page 3-3
"Cleaning the Mirror, Lenses, Motors and Iris" on page 3-4
"Cleaning the Color Wheel, Static Litho Wheel, Effects Wheel and Sensors" on page 3-7
"Cleaning the Infrared Filter, Reflector, Color Mixing Flags and Dim Flags" on page 3-10