Figure 1-3. Removing The First Four Rear Panel Screws In Order To Access The Cyberlight Voltage Selection Jumpers; Figure 1-4. In Order To Remove The Lamp Box Access Door, You Need To Remove; The Last Two 5/32 Inch Allen Screws, Which Are Located By The Color Mixing And Dim Flags - High End Systems Cyberlight User Manual

3.
1-12 Cyberlight User Manual
Remove the fixture's lamp box access door by removing six 5/32 inch allen head screws as
follows:
• Remove the four 5/32 inch allen head screws from the bottom of the rear panel as shown in
Figure 1-3.
Figure 1-3. Removing the first four rear panel screws in order to access the
Cyberlight voltage selection jumpers.
• Remove the last two 5/32 inch allen head screws from the color mixing plate as shown in
Figure 1-4.
Remove these two 5/32 inch allen screws
Figure 1-4. In order to remove the lamp box access door, you need to remove the last
two 5/32 inch allen screws, which are located by the color mixing and dim flags.
Color mixing plate