Snmpv3 Configuration Example - HP 830 Series Configuration Manual

Poe+ unified wired-wlan switch switching engine web-based
Hide thumbs Also See for HP 830 Series:
Table of Contents

Advertisement

Figure 108 Adding a trap target host
b.
Select the IPv4 option, enter 1.1.1.2 in the subsequent field, enter public in the Security Name
field, and select v1 from the Security Model list.
c.
Click Apply.
Configuring the NMS
CAUTION:
The configuration on the NMS must be consistent with the configuration on the agent. Otherwise, you
cannot perform corresponding operations.
To configure the NMS:
1.
Configure the SNMP version for the NMS as v1 or v2c.
2.
Create a read-only community and name it public.
3.
Create a read and write community and name it private.
For how to configure the NMS, see the NMS manual.
Verifying the configuration
After the configuration, an SNMP connection is established between the NMS and the agent. The
NMS can get and configure the values of some parameters on the agent through MIB nodes.
Disable or enable an idle interface on the agent, and you can see the interface state change traps
on the NMS.

SNMPv3 configuration example

Network requirements
As shown in
of the AP (the agent) at 1.1.1.1/24, and the AP automatically sends traps to report events to the NMS.
The NMS and the agent perform authentication when they set up an SNMP session. The authentication
algorithm is MD5 and the authentication key is authkey. The NMS and the AP also encrypt the SNMP
packets between them by using the DES56 algorithm and the privacy key prikey.
Figure
109, the NMS (1.1.1.2/24) uses SNMPv3 to monitor and manage the interface status
113

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents