Adding Rules To An Snmp View - HP 830 Series Configuration Manual

Figure 92 Creating an SNMP view (2)
6. Configure the parameters as described in
7. Click Add to add the rule into the list at the lower part of the page.
8. Repeat steps 6 and 7 to add more rules for the SNMP view.
9. Click Apply.
To cancel the view, click Cancel.
Table 34 Configuration items
Item
View Name
Rule
MIB Subtree OID
Subtree Mask

Adding rules to an SNMP view

1. Select Device > SNMP from the navigation tree.
2. Click the View tab.
The page in
3. Click the
The Add rule for the view ViewDefault window appears.
Description
Set the SNMP view name.
Select to exclude or include the objects in the view range determined by the MIB
subtree OID and subtree mask.
Set the MIB subtree OID (such as 1.4.5.3.1) or name (such as system).
MIB subtree OID identifies the position of a node in the MIB tree, and it can uniquely
identify a MIB subtree.
Set the subtree mask, a hexadecimal string. Its length must be an even number in the
range of 2 to 32.
If no subtree mask is specified, the default subtree mask (all Fs) will be used for
mask-OID matching.
Figure 90 appears.
icon of the target view.
Table 34.
103