Figure 93 Adding rules to an SNMP view
4.
Configure the parameters as described in
5.
Click Apply.
NOTE:
You can also click the
then you can enter the page to modify the view.
Configuring an SNMP community
1.
Select Device > SNMP from the navigation tree.
2.
Click the Community tab.
The page for configuring an SNMP community appears.
Figure 94 Configuring an SNMP community
3.
Click Add.
The page for creating an SNMP community appears.
icon corresponding to the specified view on the page shown in
104
Table
34.
Figure
90, and