Logging In From The Controller Engine - HP 830 Series Configuration Manual

Table 3 Default Web login settings
Item
Username
Password
Default IP address
To log in to the switching engine through HTTP:
1. Connect the GigabitEthernet interface of the device to a PC by using a crossover Ethernet cable.
By default, all interfaces belong to VLAN 1.
The PC in this procedure is used for configuring basic device settings, and it is not necessarily the
PC you use for Web-based management.
2. Configure an IP address for the PC and make sure the PC and device can reach each other.
For example, assign the PC an IP address (for example, 192.168.0.7/24) on the same subnet as
the switching engine.
3. Open the browser, and input the login information.
a. In the address bar, type the IP address http://192.168.0.101, and press Enter.
The login page of the Web interface (see
b. Enter the username admin, password admin, and the verification code, and click Login.
Figure 13 Logging in to the Web interface

Logging in from the controller engine

To log in to the switching engine from the controller engine:
1. Log in to the controller engine as described in
The procedures for logging to the controller engine through HTTP are the same as logging in to the
switching engine, except that you need to enter the default IP address of the controller engine.
2. Use the oap management-ip ip-address slot 0 command in system view to specify the management
IP address of the switching engine at the CLI.
This example uses the default management IP address of the switching engine.
3. On the Web interface of the controller engine, click Switch Engine.
The switching engine login page appears.
4. Enter the login settings.
Controller engine
admin
admin
192.168.0.100/24
Figure
Logging in through
19
Switching engine
admin
admin
192.168.0.101/24
13) appears.
HTTP.