HP 830 Series Configuration Manual page 84

Poe+ unified wired-wlan switch switching engine web-based
Hide thumbs Also See for HP 830 Series:
Table of Contents

Advertisement

Figure 61 Loopback test result
When you configure a loopback test, follow these guidelines:
You can perform an internal loopback test but not an external loopback test on a port that is
physically down. You can perform neither test on a port that is manually shut down.
The system does not allow Rate, Duplex, Cable Type, and Port Status configuration on a port under
a loopback test.
An Ethernet port operates in full duplex mode when the loopback test is performed. It restores its
original duplex mode after the loopback test.
72

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents