Placing Originals In The Adf - Oce 3122 Manual

3 Gently lower the platen cover (or ADF or RDF).
NOTICE
When placing originals on the platen glass, the size of the
original is detected after the platen cover (or ADF or RDF) has
been lowered. Be sure to lower the platen cover/ADF/RDF
before copying.
REQUEST
Do not press down hard on the platen cover (or ADF or RDF)
when using the platen glass to copy thick books. This may
damage the platen glass.

Placing Originals in the ADF

Place a stack of originals in the ADF, and they are automatically fed to the platen glass for copying.
You can place the following originals in the original supply tray:
· Weight:
· Size:
· Tray capacity:
REQUEST
Do not place objects in the document tray. Doing so might damage originals that are output to the document tray.
NOTICE
Only one copy can be made when using the ADF.
Do not place the following types of originals in the ADF:
· Originals with tears or large binding holes
· Severely curled originals or originals with sharp folds
· Clipped or stapled originals
· Carbon-backed paper or other originals which might not feed smoothly
· Transparencies and other highly transparent originals
Do not bring paper or your hands within 5 cm of the paper sensors on the ADF during copying. Doing so may
result in erroneous copying.
MEMO
Names and functions of ADF parts (See p. 6-8 in the Reference Manual .)
1 Adjust the slide guides to fit the size of the originals.
2-14
Océ 3121 – Copying Manual – English
2 2
35 g/m to 105 g/m (The Thin Sheet Original mode must be set for originals
such as invoices that are over 35 g/m
A5, A4, A3
2
A3-size: 15 (80 g/m ),
2
A5/A4-size: 30 (80 g/m )
2 2
but less than 50 g/m .)
Slide guides