Designating Areas - Oce 3122 Manual

How to Designate Areas for Image-processing
To designate an area on the original, you must designate two opposite corners, the top right and
bottom left corners. These corners are expressed by the coordinates [X1], [Y1] and [X2], [Y2]. Each
of these coordinates are designated in millimeters with the Number keys.
Up to four areas can be designated for Framing, Blanking, Nega/Posi image creation features and
image repeat/mirror image features.
Designate [X1], [X2], [Y1] and [Y2] as follows:
[X1] : Length from the right edge of the original to the
right edge of the area
[X2] : Length from the right edge of the original to the
left edge of the area
[Y1] : Length from the top edge of the original to the top
edge of the area
[Y2] : Length from the top edge of the original to the
bottom edge of the area
NOTICE
The maximum values that can be designated for X and Y
are as follows:
X: 432 mm
Y: 297 mm

Designating Areas

Designate the area of the image to be processed as follows.
1 Press the [AREA DESIG.] key.
MEMO
For details on operations to carry out from placing the original
until the Special Features screen is displayed, see chapter 4,
"Calling up the Special Features Screen," on p. 4-3.
2
Designate the area with the [X1], [Y1], [X2] and [Y2]
keys, enter each of the values using the Number
keys, then press the [OK] key.
MEMO
[X1] : Length from the right edge of the original to the right edge
of the area
[X2] : Length from the right edge of the original to the left edge
of the area
[Y1] : Length from the top edge of the original to the top edge of
the area
[Y2] : Length from the top edge of the original to the bottom
edge of the area
If you enter the wrong values, press the
The maximum values that can be designated for X and Y are as
follows:
X: 432 mm
Y: 297 mm
5-4
Océ 3121 – Copying Manual – English
key and start again.