Oce 3122 Manual page 197

5 Holding the negative film carrier level insert into the
right-hand side as far as
carrier (so that the empty frame is aligned).
6 Set the lamp switch to the
[OK] key.
MEMO
When you turn the lamp switch ON, the Film Projector's lamp
lights.
NOTICE
About 60 minutes after the lamp lights, it goes out. This is to
protect the film. To light the lamp after it has gone out, turn the
Film Projector's power switch OFF then back ON again after a
short while.
7
After making sure that the lamp is lit, turn the
brightness dial to the left as far as it will go, and
press the [OK] key.
Océ 3121 – Copying Manual – English
mark on the side of the
position, and press the
1
2
3
4
5
6
7
8
9
10
7-9