Oce 3122 Manual page 208

5 Set the lamp switch to the
the [OK] key.
MEMO
When you turn the lamp switch ON, the Film Projector's lamp
lights.
NOTICE
About 60 minutes after the lamp lights, it goes out. This is to
protect the film. To light the lamp after it has gone out, turn the
Film Projector's power switch OFF then back ON again after a
short while.
6 After making sure that the lamp is lit, turn the light
adjustment dial to the left as far as it will go, and
press the [OK] key.
7 After adjusting the intensity with the dial to the
adjustment position, press the [OK] key.
Scanning for internally adjusting the Film Projector is
carried out.
During this adjustment, the screen on the right
appears.
MEMO
To cancel scanning, press the
7-20
Océ 3121 – Copying Manual – English
position, and press
or key.