How To Setup And Disconnect The Film Projector; How To Set Up The Film Projector - Oce 3122 Manual

How to Setup and Disconnect the Film
Projector

How to Set up the Film Projector

Before using the Film Projector, remove any tape used for securing parts on the Film Projector.
Referring to the figure on the previous page, make sure that you have all the parts.
1 Place the Film Projector on the platen glass.
Place the Film Projector on the platen glass making
sure that it faces the direction shown in the figure on
the right. Align the two lugs on the bottom of the Film
Projector with the two holes at the front of the platen
glass.
2 Plug in the power cord.
Plug the power cord into the power cord connector
located on the projector's left panel. Plug the other
end of the power cord into a power socket.
Set the lamp housing upright.
3
Set the lamp housing upright while supporting it from
its bottom. When the lamp housing is fully upright,
you will hear it click into place.
Océ 3121 – Copying Manual – English
Lamp housing
7-3
1
2
3
4
5
6
7
8
9
10