Making Copies Using Image Processing Features (Image Creation); Inverting Original Images (Nega/Posi); Image Creation - Oce 3122 Manual

Making Copies Using Image Processing Features

(IMAGE CREATION)

This mode allows you to perform image processing on original images.
You can process images in the following four ways.
NEGA/POSI (See p. 5-8.)
Makes copies of only the inside of a designated area on the original with the original image
inverted. (For details, see "How to Designate Areas for Image processing," on p. 5-4.)
MEMO
To invert a part of the original image, you can start by setting the Area Designation feature. (For details, see
"How to Designate Areas for Image processing," on p. 5-4.)
IMAGE REPEAT (See p. 5-9.)
Makes copies of the original image repeated in the vertical direction. You can also designate an
original image as an area, and make copies of only the image in this area repeated in the vertical
direction.
MIRROR IMAGE (See p. 5-12.)
Makes copies of the original image flipped around the horizontal or axis. You can also make mirror-
imaged copies of designated areas. Three Mirror Image modes are available: [MIRROR IMAGE],
[BOTTOM SYMMETRY] and [TOP SYMMETRY].
SLANTED IMAGE (See p. 5-15.)
Makes copies of the original image slanted at a designated angle.

Inverting Original Images (NEGA/POSI)

Make copies of the entire original inverted as follows.
1 Press the [IMAGE CREATION] key.
MEMO
For details on operations to carry out from placing the original
until the Special Features Screen is displayed, see "Calling up
the Special Features screen," on p. 4-3.
When inverting the entire original, you need not designate the
area.
5-8
Océ 3121 – Copying Manual – English
Original Copy