Digital Signage - Cisco Webex Room Panorama Administrator's Manual

Cisco Webex Room Panorama and Room 70 Panorama

Introduction
Web view based features

Digital signage

Digital signage allows you to show custom content (a web page)
on a device when it's in half-wake state. Digital signage is a way
to display advertising content and promote your brand, but also
to show visitor and internal employee information, dashboards, or
calendars.
The content replaces the traditional half-wake background image
and information, and is always shown on full screen. Only one
web window or tab is supported. If a web page tries to open a
page in a new window or tab, it replaces the current page.
Data, such as cache, cookies, and local storage, is NOT
automatically cleared when the device restarts. You must use the
delete storage command to delete the data.
xCommand WebEngine DeleteStorage [Type: WebApps]
•
If a web page is not supported, the device goes directly to
normal half-wake mode. You can see more information in the
Maintenance > Diagnostics page in the web interface of the
device.
D15439.02 Room Panorama and Room 70 Panorama Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals
Set up digital signage
1. Sign in to the web interface and navigate to
Configuration.
2. Set WebEngine > Mode
3. Set Standby > Signage > Mode
signage.
4. Enter the URL of the web page that you want to show in
Standby > Signage >
5. The web page is shown before the device enters standby
mode. Use the following settings to determine for how long
the web page is shown.
Standby >
mode (not recommended). If set to On, the device enters
standby mode when the Standby > Delay has timed out.
Standby >
shows the web page before going into standby mode.
Standby >
wakes up automatically from standby, and starts showing
the web page when people enter the room. If set to Off, the
device is not affected by people entering the room.
Other digital signage settings:
• Decide whether to play out the audio for web pages that have
audio.
Standby > Signage > Audio
• Force a web page to refresh at regular intervals. This is useful
for web pages that don't refresh themselves.
Standby > Signage > RefreshInterval
Maintenance
Setup >
to On to enable the web engine.
to On to enable digital
Url.
Mode: If set to Off, the device never enters standby
Delay: Define how long (in minutes) the device
WakeUpOnMotionDetection: If set to On, the device
205
Administrator Guide
Device settings
The web engine
All web view based features are using the
web engine. Therefore the web engine
must be enabled before you can use a
web view based feature.
The web engine is based on Chromium /
Qt WebEngine with V8 JavaScript. The
Chromium version is updated regularly,
but it might be older than your Chrome
laptop version.
These features are not supported: PDF,
WebGL WebRTC, password manager,
plug-ins, downloading and uploading
files, and notifications.
Remote debugging
If you encounter a problem with a web
page, you can turn on remote debugging.
WebEngine > RemoteDebugging
Remote debugging lets you access the
Chrome developer console and identify
potential issues with a web page. When
enabled, a banner is displayed at the
bottom of the screen, warning the users
that they may be monitored. The banner
also shows the URL that you can enter in
your local Chrome browser to open the
developer console.
Using a proxy
You can set up the device to use an HTTP
proxy for web view based features.
NetworkServices > HTTP Proxy
Additionally, this setting must be On:
WebEngine > UseHttpProxy
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
Appendices Appendices