Network Settings; Network Settings Screen Details - Dell EMC PowerEdge T440 Installation And Service Manual

Network Settings

You can use the Network Settings screen to modify UEFI PXE, iSCSI, and HTTP boot settings. The network settings option is available
only in the UEFI mode.
NOTE: The BIOS does not control network settings in the BIOS mode. For the BIOS boot mode, the optional Boot ROM of the
network controllers handles the network settings.
Viewing Network Settings
To view the Network Settings screen, perform the following steps:
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Network Settings.

Network Settings screen details

The Network Settings screen details are explained as follows:
Option Description
UEFI PXE Settings Enables or disables the device. When enabled, a UEFI PXE boot option is created for the device.
UEFI HTTP Settings Enables or disables the device. When enabled, a UEFI HTTP boot option is created for the device.
UEFI iSCSI Settings Enables you to control the configuration of the iSCSI device.
Table 31. UEFI iSCSI Settings screen details
Option
iSCSI Initiator Name
iSCSI Device1
iSCSI Device1 Settings
Description
Specifies the name of the iSCSI initiator in IQN format.
Enables or disables the iSCSI device. When disabled, a
UEFI boot option is created for the iSCSI device
automatically. This is set to Disabled by default.
Enables you to control the configuration of the iSCSI
device.
Dell EMC PowerEdge T440 Installation and Service Manual
Pre-operating system management applications
53