I Sub Band Mute/Sub Band Busy Beep - Icom IC-2725E Instruction Manual

3
BASIC OPERATION

I Sub band mute/sub band busy beep

The sub band mute function automatically cuts out sub band
audio signals when both main and sub band signals are re-
ceived simultaneously.
While operating on the main band, a beep sounds to inform
you that a signal was received on the sub band.
MAIN
T X
qWhile pushing [SET•
initial set mode.
While pushing [SET•
push [PWR] to enter initial
set mode
wPush [SET•
] or [LOW•PRIO] until "SUb" appears in the
display as shown above.
19
The display shows that
the sub band mute is
turned ON and sub band
M
busy beep is turned ON.
], push [PWR] for 1 sec. to enter
]
e Rotate the left band's [DIAL] to select the condition.
DISPLAY SUB BAND MUTE
SUb-OF OFF
SUb-OF S
OFF
SUb-On
SUb-On S
rPush [PWR] momentarily, to exit initial set mode and return
to the previous indications.
INITIAL SET MODE
USING
BUSY BEEP
OFF
ON
ON OFF
ON ON