Icom ID-1 Instruction Manual page 94

11
SCAN OPERATION
• Call Sign— YOUR, RPT1, RPT2
Clck to select the cell, then enter the desred staton or
repeater call sgn from the PC keyboard drectly.
• Memory Name
Clck to select the cell, then enter the desred memory
name from the PC keyboard drectly.
t Repeat the steps w to r to program another scan edge
channel.
y To close the Memory Channel screen, clck " " n tool bar
or clck " . "
87
D Programming with the RC-24
q Set the desred scan edge frequency n VFO mode.
➥ Set the operatng mode wth [MODE]
➥ Set the frequency usng [DIAL] or keypad.
➥ Set other data (e.g. staton call sgn, tone nformaton,
etc.) f requred.
w Push [MW•6] momentarly.
• Memory channel number blnks.
[MW•6]
e Rotate [DIAL] to select a scan edge channel to be pro-
grammed.
• Select "MPA" as the PA, "MPB" as the PB channel.
r Push [MW•6] for 0.5 sec. to program.
• 3 beeps sound.
• Scan edge channel number automatcally ncreases when con-
tnung to push [MW•6] after programmng.
t Repeat the steps q to r to program the another scan
edge channel.