Icom ID-1 Instruction Manual page 83

• Call Sign— YOUR, RPT1, RPT2
Clck to select the cell, then enter the desred staton or
repeater call sgn from the PC keyboard drectly.
• SKIP
Double clck then select the skp condton.
• Not selectable for the scan edges and call channels.
• Memory Name
Clck to select the cell, then enter the desred memory
name from the PC keyboard drectly.
t Repeat the steps w to r to program another memory or
call channels.
y To close the Memory Channel screen, clck " " n tool bar
or clck " . "
MEMORY/CALL OPERATION
D Programming with the RC-24
q Set the desred frequency n VFO mode.
➥ Set the operatng mode wth [MODE].
➥ Set the frequency usng [DIAL] or keypad.
➥ Set other data (e.g. staton call sgn, tone nformaton,
etc.), f requred.
w Push [MW•6] momentarly.
• The prevously selected memory channel number blnks.
[MW•6]
1294.500
FM
e Rotate [DIAL] to select the desred memory/call channel
to be programmed.
• Push [V/M] to select the prevously selected memory chan-
nel (the same memory channel as dsplayed at step w), push
[CALL] to select call channel 1.
• Select "MC1" as the call channel 1, "MC2" as the call channel 2
and "MC3" as the call channel 3.
r Push [MW•6] for 0.5 sec. to program.
• 3 beeps sound.
• Memory channel number automatcally ncreases when contnu-
ng to push [MW•6] after programmng.
10
LOW
10
M00
76