ProgrammNg Scan Edge Channels - Icom ID-1 Instruction Manual

11
SCAN OPERATION
■ Programming scan edge channels
Scan edges can be programmed n the same manner as
memory channels. Scan edges are programmed nto scan
edges PA and PB, n memory channels.
D Programming from the application
— main screen
q Set the desred scan start frequency n VFO mode.
➥ Set the operatng mode wth [MODE]
➥ Set the frequency usng [DIAL] or keypad.
➥ Set other data (e.g. staton call sgn, tone nformaton,
etc.) f requred.
w Clck [MW] to dsplay the Memory programmng screen.
85
e Select the memory channel "PA" by rght clckng or left
clckng on the [DIAL] n the screen.
• Clck to select "MEMORY" f call s selected.
Click to
select.
Shows the selected scan
edge channel and previously
programmed frequency.
r Clck [MW] on the Memory programmng screen to pro-
gram.
Click
t Set the desred scan end frequency n VFO mode as the
step q.
y Select the memory channel "PB," then clck [MW] n Mem-
ory programmng screen to program.
u To close the Memory programmng screen, clck [MW] on
the man screen agan or clck " . "
Select "PA" or "PB"
channel.
Click