Icom ID-1 Instruction Manual page 93

D Programming from the application
— Memory Channel screen
q Dsplay the Memory channel screen.
- Select "Edt Memory Channel(M)..." n Vew menu.
- Clck " " n tool bar.
- Press [F6] key on the PC keyboard.
w Clck to select the "Freq." cell of ether the scan edge
channel, PA or PB, then enter the desred operatng fre-
quency from the PC keyboard drectly.
e Double clck the Mode cell n the same memory/call chan-
nel, then select the desred operatng mode.
Click to select, then enter
the desired scan edge
frequency.
Double click the
Mode cell, then
select the desired
operating mode.
r Set the other tems as follows.
• Repeaters— RP
Double clck the cell, then select the
desred duplex condton.
• Repeaters— Offset Freq.
Clck to select the cell, then enter the desred offset fre-
quency from the PC keyboard drectly.
• TONE/TSQL— Tone Select
Double clck the cell, then select the
desred tone condton.
• TONE/TSQL— Repeater Tone, TSQL Tone
Double clck the cell, then select the
desred tone frequency.
• Digital— DSQL
Double clck the cell, then select the
desred dgtal squelch condton.
• Digital— Code
Clck to select the cell, then enter the desred dgtal code
number from the PC keyboard drectly.
11
SCAN OPERATION
11
86