GCC Technologies Elite 21DN User Manual page 311

Hide thumbs Also See for Elite 21DN:
Table of Contents

Advertisement

FEDERAL COMMUNICATIONS COMMISSION
WARNING:This equipment was tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions in this manual, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. For more information about radio frequency
interference, refer to the section of this manual on Radio and TV interference.
CANADIAN REGULATIONS
This equipment is a Class A digital apparatus that complies with the Radio Interference Regulations, CRC c. 1374.
IMPORTANT:
Changes or modifications to this product not authorized by GCC Technologies Inc. could void the FCC
Certification and negate your authority to operate the product. This product was tested for FCC Compliance under
conditions that included the use of shielded cables and connectors between system components. It is important that you
use shielded cables and connectors to reduce the possibility of causing interference to radios, television sets, and other
electronic devices. You can obtain the proper shielded cables from GCC Technologies or from an Authorized GCC
Technologies dealer.
CLASS 1 LASER PRODUCT
LASER SAFETY:This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human Services
(DHHS) Radiation Performance Standard according to the Radiation Control for Health and Safety Act of 1968. This means
that the printer does not emit hazardous radiation. Since radiation emitted inside the printer is completely confined within
protective housings and external covers, the laser beam cannot escape from the machine during any phase of user operation.
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented regulations
for laser products on August 1, 1976. These regulations apply to laser products marketed in the United States. The label on
the printer indicates compliance with the CDRH regulations and must be attached to the laser products marketed in the
United States.
Caution - Use of controls, adjustments, or performance of procedures other than those specified
in this manual may result in hazardous radiation exposure.
CREDITS
© Copyright GCC Technologies Inc., 2003. All rights reserved.
The Elite 21 User's Manual was written by David Nicholson.
It was edited by Donna Atwood, Kevin Curran, Donald Damon, Lee Doron,Victor Fay, Laurie Freitas, Brian
Harriss,Wendi LeBlanc and Gregg Linzey.
Illustrations courtesy Xerox International Partners,Technical Services Group. Additional illustrations by
Adam DeFanti. Layout by Adam DeFanti and David Nicholson. Cover design and layout by Adam DeFanti.
Printed in USA; part number 030-16479 rev C.
J-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite 21nElite 21 seriesElite 21dn+Elite 21n+

Table of Contents