Table of Contents
Advertisement
4. Define the Printer.
• Press ENTER with the new Print Server Highlighted, select Print Server
Configuration, then select Printer Configuration.
• Select Printer 0 and define a more meaningful name for the printer if desired.
The printer name is displayed in various NetWare printing messages such as
when notifying users that their job is completed.
• Set the TYPE field to Remote/Other Unknown.
• Press ESCAPE to exit and select Yes to save the changes. Press ESCAPE again to
return to the Printer Server Configuration menu.
5. Assign the Print Queue.
• Select Queues Serviced By Printer, highlight the desired printer on the Defined
Printers list and press ENTER.
• Press INSERT to display the Available Queues List. Select the desired queue and
assign a Priority level (recommended choice is 1).
• Press ESCAPE when finished and continue pressing ESCAPE to exit PCONSOLE.
6. Confirm Successful Configuration.
• Turn the printer off and on and wait for a power-up network status page to print.
If the network is large, the power-up status page may take several minutes to
print. (Note:This time may be reduced by setting a Preferred File Server for the
printer with the Management Access Program. Refer to Chapter 9 of this manual
(Using WebAdmin) for more information.)
• The Novell Connection Information in the bottom half of the status page displays
the printer name, file server, queue, etc. If it displays Attached:Yes, this confirms
that the printer is ready to accept print jobs.
• If the status page does not display Attached:Yes, please verify that the Novell
Print Server Name on the status page under Novell Network Information
matches exactly with the Print Server name that was entered in PCONSOLE.
8-29
Advertisement
Table of Contents
