Table of Contents
Advertisement
Specifying Transmit Once Collation Mode
The Elite 21 printer can operate in two different collation modes:
• Transmit Once Collation Mode:When multiple copies of a single document are
sent, the print driver on the computer sends the job once, then subsequent
copies are processed directly by the printer.
• Driver Collation Mode:When multiple copies of a single document are sent, the
driver on the computer generates and sends the print job to
the printer once for each copy required
Transmit Once Collation Mode results in faster printing in most cases and frees up
resources on the computer. Printers with less installed RAM, however, may experience
errors when trying to print more complex jobs in
this mode. If PostScript errors occur when using Transmit Once Collation Mode, you
may want to add memory to the printer to increase the space for job storage, or
switch back to Driver Collation Mode.
To enable Transmit Once Collation Mode, follow these steps:
• Make sure the printer's display is reading "Ready".
• Press either Menu key until "Configuration" appears.
• Press either Item key until "Collation Mode" appears.
• Press either Value key until "Transmit Once" appears.
• Press Select to accept the change.
• Restart the printer to enable the new settings.
The settings on the computer(s) that are to use the printer will also need to be
modified to reflect this change, as follows:
10-15
Advertisement
Table of Contents
