Table of Contents
Advertisement
7. Set Up and Reset the Printer
• NWADMIN configuration is complete. Before you can begin printing, however,
follow the steps in the next section (Printer Configuration) and reset (power
cycle) the printer.
Printer Configuration
WebAdmin must used to define the context and tree of the Print Server. It is also
used to change the Print Server name, set a password, modify scan and frame search
parameters, and set bindery-mode specific values.
Use the MAP utility or type the printer's IP address into your web browser (refer to
Chapter 9) to access the WebAdmin pages of the printer. Once you have accessed
WebAdmin, click on "Network" from the options on the left and do the following:
1. Select Setup NetWare under Protocols.
2. Select Enable NetWare. If it is not selected, the NetWare protocols will not come
up, the printer will not appear as an advertised device, and the printer will not be
accessible using IPX SNMP.
3. The default name for the NetWare Print Server is GCC and a six-digit number
(i.e. GCC_123456). This is also the default name of the printer in peer-to-peer
mode. If you want to change the default Print Server name, type this name in the
Print Server Name space. Leave the space blank if the default name is to be used.
4. If you want the printer to login with a password, this password may be entered in
the Print Server Password field, and again in the Password Retype field. If a
password is used, this password must be the same password for all bindery-based
and NDS-based Print Server entries.
5. Enter the name of a preferred bindery-based file server in the Preferred File
Server field. The Preferred File Server entry is significant only for bindery or
bindery emulation based operations. The Print Server must be configured on the
preferred file server. Incorrect setup of a Preferred File Server can interfere with
NetWare printing.
8-36
Advertisement
Table of Contents
