Table of Contents
Advertisement
Installable Options controls the following settings:
Additional Trays: Sets whether additional trays are present or not.
Envelope Feeder: Sets whether the envelope feeder is present or not.
Offset Bin: Sets whether the upper output bin is present or not.
Duplex Unit: Sets whether the duplex unit is present or not.
Internal Hard Disk: Sets whether an internal hard disk is present or not.
Collation Mode: Sets 'collation in printer' mode (i.e. - whether the printer handles job collation,
or if each copy is sent individually by the print driver). This setting should match the
"Collation" setting on the printer's front panel Configuration menu.
Paper Sizes: Sets whether US and International sizes are made available, or just US or
International.
VM Option: Sets the amount of memory installed in the printer.
To change any option in Device Options, click on the option on the list. The "Change Setting"
section at the bottom of the page will display the option you chose. You can then change the
setting from the pull-down menu. The new setting should then appear on the list in the upper
window. Click Apply and OK to accept when all changes are made.
The final tab in the Properties windows is PostScript. This section contains settings for PostScript
output format, PostScript headers, error information and timeout values. The default settings in this
category should suit the needs of most users.
Changes made within the Driver Properties window will be set as printer defaults unless changed by
returning to Properties.
4-28
Advertisement
Table of Contents
