Table of Contents
Advertisement
Windows 95/98 and Windows ME Configuration
The Elite 21 CD-ROM contains software to allow the printer to be accessed as a peer-to-
peer device on a Windows 95/98/ME Ethernet network. This includes software to allow
the printer to be accessed as a peer-to-peer device using TCP/IP, or using IPX/SPX. We
recommend using the TCP/IP option for most users, if you prefer to use IPX, see
instructions on
Page
Configuring a peer-to-peer connection via TCP/IP
First, make sure that TCP/IP is enabled and configured within Windows. To do this, go to
the Start menu, then to Settings, Control Panels, and select Network. Click on Protocols,
and make sure "TCP/IP Protocol" is present on the list of supported protocols. If not, click
on Add to install it. Consult your Windows documentation for more information. Once
installed, click on TCP/IP Protocol from the list of supported protocols, click Properties and
enter all necessary TCP/IP settings for the PC. Your network administrator may need to
assist with this process.
Once the PC is set up to use TCP/IP, confirm that all the TCP/IP settings are properly set
on the printer. If an IP address has not been assigned to the printer, assign one following
the instructions at the beginning of this chapter.
Make sure that the PC and printer are both properly connected to the network, then run
the IP-P2P software located on the Elite 21 CD-ROM. This software will create a TCP/IP
port for the printer within Windows and allow you to select the printer using that port.
To install the IP-P2P software on the PC, follow these steps:
• Insert the Elite 21 CD-ROM into the PC.
• Open the "My Computer" icon from the desktop, and double-click the CD-ROM icon
to open the CD window.
• Double-click the Network folder on the Elite 21 CD-ROM, then double-click the IP-
P2P 2.70 folder, then the file called "SETUP.EXE" within this folder.
• This will run the IP-P2P installer. Follow the steps in the installer to install the
software.
Once the IP-P2P software is installed, you can run the program to create the TCP/IP port
for the printer, as follows:
8-12.
8-7
Advertisement
Table of Contents
