Table of Contents
Advertisement
5. Printing (continued)
• Edge To Edge: Specifies whether edge-to-edge printing is Enabled or Disabled. See
Chapter 10 for more details on edge-to-edge printing.
• Vertical Shift:Allows the top-to-bottom alignment of the page to be adjusted up or
down in intervals of one point (1/72", 0.35mm).
• Horizontal Shift:Allows the side-to-side alignment of the page to be adjusted left or
right in intervals of one point (1/72", 0.35mm).
• Append CR to LF:Appends a carriage return to the end of each line of a plain-text
PCL job to allow the job to print out with proper formatting. Default is Enabled.
• Print Errors: Specifies whether the printer will automatically generate a detailed report
of any PostScript printer errors. Default is Disabled.
6. Configuration
This menu controls items related to the way that basic functions of the printer are
configured. The items are as follows:
• Energy Save: Controls amount of time that the printer will remain idle before
switching to Energy Save mode. Default is 15 minutes.
• Collation Mode*: Sets whether collation is handled by the printer or by the computer.
If Disabled, the printer driver on the computer will send the job once for each
collated copy. If Enabled, the driver will send the job once and the printer will hold
the job in memory and generate subsequent copies automatically. This mode is faster,
but takes up more memory.
• Hold Last Job*: Sets the Held Job feature described under the Held Job menu (see #1)
to Enabled or Disabled.
• RAM Disk *:Allows a portion of the printer's RAM to be set aside as a RAM Disk. This
area can store often-used fonts, held jobs, etc. to speed up processing time. This
reduces the amount of available processing RAM, however, and is only recommended
in cases where the printer's RAM has been upgraded. Default is Disabled.
• Language: Specifies the language used on the printer's LCD display and internal pages.
Default is English, also available are French, Italian, German and Spanish.
• Startup Page: Determines whether a startup page is generated when the printer is
powered on. Default is Enabled.
Note: Changes made to items marked with an asterisk (*) will not take effect until the
printer is restarted.
7-8
Advertisement
Table of Contents
