Loading The Bypass Tray - Xerox WorkCentre 5790 User Manual

Bypass Tray

Loading the Bypass Tray

Your device alerts you if the Bypass Tray is selected for a job and the media requested does not match
the media currently loaded. It also warns you if the tray runs out of paper during a job.
1. Make sure the tray is in the down position. For larger
media, use the tray extension.
2. Place the media on the tray. Locate the media to the
right edge.
• Load pre-printed paper and labels face-up and
with the top towards the front of the device.
• Load hole punched paper with the holes on the
right.
• Load transparencies face-up with the white strip
on the right.
For information about loading tabs, refer to
Paper must not be loaded above the maximum fill line.
3. Make sure that the guides just touch the paper.
The paper settings for the tray are displayed on the
touch screen.
The tray detects the position of the side guide to
determine the size of the media.
4. Confirm or change the settings, as required.
228 WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Paper and Media
Media Types on page 233.