Xerox WorkCentre 5790 User Manual page 297

Problem
Paper Curls
The Finisher does not stack the
output correctly
The Finisher does not staple or
hole punch correctly
Stray marks or black marks
from hole punched originals are
not removed
Images are out of sequence or
upside down when the Booklet
Creation feature is used
The output is blank
Potential Solution
• Load the paper in the paper trays with the seam side of the paper up.
Load the paper in the Bypass Tray with the seam side down.
• Load non-standard media in the Bypass Tray.
• If the paper curls excessively, flip the paper over in the applicable paper
tray.
• Unload the finisher tray frequently.
• Do not remove stapled sets while the finisher is compiling.
• Check the paper tray guides are locked into position against the paper.
• When using large paper, remove any output contained in the Stacker
Tray.
• Load the paper in the paper trays with the seam side of the paper up.
Load the paper in the Bypass Tray with the seam side down.
• Load non-standard media in the Bypass Tray.
• If the paper curls excessively, flip the paper over in the applicable paper
tray.
• Check the correct paper size has been selected for the paper loaded in
the tray.
• To correct stapling problems, ensure the maximum number of sheets is
not exceeded for the finisher being used.
• The maximum number of sheets when stapling heavyweight paper is
determined by the finisher type. The Basic Office Finisher staples 12
sheets of heavyweight paper, the Office Finisher staples 20 sheets of
heavyweight paper, and the High Volume Finisher staples 30 sheets.
• Check the correct option has been selected on the touch screen.
• Check the touch screen for a fault message indicating no staples.
Replace the staple cartridge.
• When using large paper, remove any output contained in the Stacker
Tray.
• Check that the hole punch waste container is not full. The hole punch
waste container collects waste from the hole punch.
• Check the correct paper size has been selected for the paper loaded in
the tray.
• Check the paper tray guides are locked into position against the paper.
• Use the Edge Erase option to erase the edge with the punched holes.
Refer to Edge Erase on page 54 of Copy.
• Copy from the document glass with the document cover or document
feeder down.
• Ensure that the originals are in the correct sequence.
• Feed LEF originals to SEF orientated paper.
• Enable the display options for Booklet Creation and ensure that the
correct sequence is selected (i.e. Left to Right or Right to Left).
• Ensure the originals are loaded either face up in the document feeder or
face down on the document glass in the top right position.
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
General Care and Troubleshooting
Troubleshooting
297