Xerox WorkCentre 5790 User Manual page 234

Media Types
Media Type
Labels
Pre-Cut Tabs
Heavyweight
Rough Surface
(optional on some
configurations)
234 WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Paper and Media
Description
Labels that have been
designed for laser devices,
such as Xerox Labels are
supported. The adhesives
are designed to withstand
the higher temperatures of
these devices without
bleeding and causing
spotting or damage to the
internal components.
Note: Dry gum labels can
cause dry particles of glue
to detach from the backing
and should not be used.
Tabs are used as dividers in
documents. Your device
can accommodate tabs
with 1 to 10 tabs and
gsm
weights of up to 200
(53 lb bond).
Note: Do not use tabs with
bent corners. They can
cause feeding related
problems. If a tab is bent,
remove it from the set and
replace it with an
undamaged tab in the
same position.
Use this media type for
feeding heavyweight paper
and card. The maximum
weight which can be fed is
gsm
216 (56 lb bond).
Use this media type for
paper which has a rough
surface.
Loading Instructions
Labels should be left in the printing environment for
72 hours before being used in the printer to allow
them to adjust to the ambient temperature.
Leave labels sealed in their plastic wrapping until
they are ready to be loaded into the printer.
Bypass Tray:
• Load labels face-up in the Bypass Tray with the
top towards the front of the device.
Note: Do not fan the label sheets before use unless
the package instructs you to do so. If jamming or
multi-sheet feeding occurs shuffle the labels before
loading. Labels can only be printed 1-sided.
Trays 1and 2:
• Load pre-cut tabs in the tray with the tab edge to
the right (on the trailing edge) with the top tab to
the front of the tray.
Bypass Tray:
• Load pre-cut tabs in the Bypass Tray with the tab
edge to the left (on the trailing edge) with the top
tab to the front of the tray.
Ensure the tab sequence and number of tab sets is
correct for the document being copied or printed, and
the quantity required.
For information about programing a tab job, refer to
Build Job on page 63 for copy jobs and
Exceptions on page 161 for print jobs.
Trays 1, 2, 3 and 4:
• Load up to 200 gsm (53 lb bond) paper.
Tray 5 and Bypass Tray:
• Load up to 216 gsm (56 lb bond) paper or card.
Paper capacities are reduced for heavyweight paper,
ensure the paper does not exceed the maximum fill
line in each tray.
Rough Surface paper can be loaded in any tray.
Add