Tray 6 (Inserter); Loading Tray 6 (Inserter) - Xerox WorkCentre 5790 User Manual

Tray 6 (Inserter)

Tray 6 (Inserter) is an optional paper tray for use with the
High Volume Finisher and is used for inserting post process
sheets in the set. This tray provides a very convenient and
efficient way of adding pre-printed covers or inserts to a
job. The following media can be loaded in Tray 6 (Inserter):
• Up to 250 sheets of 75 gsm or 20 lb paper.
• Weights from 60 to 216 gsm (16 to 56 lb).
Note: For 80 gsm paper capacities are slightly lower
than specified.
• Media sizes:
• A4 or 8.5x11" SEF or LEF
• 8.5x13" SEF
• 8.5x14" SEF
• A3 or 11x17" SEF
• Media types:
• Plain, Bond or Recycled
• Punched
• Letterhead
• Pre-printed
Tray 6 (Inserter) must not be used to feed labels, envelopes, tabs or carbonless paper. The Bypass Tray
can be used for these media types.

Loading Tray 6 (Inserter)

A4 or 8.5x11" media may be loaded either long edge feed or short edge feed. Media sizes larger than
A4 or 8.5x11" must be loaded short edge feed.
1. Place the media in the correct orientation for the job.
The labels on the top of Tray 6 (Inserter) provide
instructions for input and output orientations. Refer to
Orientation of Pre-printed Media
2. The paper is registered to the left edge of the tray.
Paper must not be loaded above the maximum fill line.
3. Make sure that the guides just touch the paper.
on page 232.
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790

Tray 6 (Inserter)

231
Paper and Media